01-07-2007, 10:31 PM
any one with acess to a bench drill and small thathe or O'D' grinder can make one.
all it is, [ul] [li]an adapter that goes from your drill to the inside shank of the auger.[/li] [li]there is also a catcher that mounts on the auger itself to keep it from falling though the hole. and yes I have seen them get sucked righ out of the drill's grip and fall.[/li] [ul] [li]the catcher can be a peice of steel that is a couple inches wider than the auger on both sides. just be sure to grind round all corners and edges because it will catch on your clothing if you dont.[/li][/ul][/ul]
home made ones work as well and store bought ones....[
]
[signature]
all it is, [ul] [li]an adapter that goes from your drill to the inside shank of the auger.[/li] [li]there is also a catcher that mounts on the auger itself to keep it from falling though the hole. and yes I have seen them get sucked righ out of the drill's grip and fall.[/li] [ul] [li]the catcher can be a peice of steel that is a couple inches wider than the auger on both sides. just be sure to grind round all corners and edges because it will catch on your clothing if you dont.[/li][/ul][/ul]
home made ones work as well and store bought ones....[
][signature]